Software para el diseño de instalaciones eléctricas de baja tensión – FASE 01
Electrical Design Software for low voltage installations v1.0
Autor
Arias Rico, Marisel
Villadiego Hernández, Orlando Enrique
Fecha
2017-05-24Resumen
En el campo de las instalaciones eléctricas en baja tensión se suele diseñar con MACROS en Excel, las cuales ahorran tiempo al realizar algunos cálculos de manera automática, sin embargo, aún la mayoría del trabajo le corresponde al ingeniero diseñador, ya que este debe seleccionar todos los elementos de la instalación eléctrica. A pesar de que se han realizado varios softwares para este tipo de diseño, el hecho de que sean creados por empresas que comercializan los productos de la instalación, hace que las selecciones estén enfocadas a referencias de sus artículos.
Este proyecto consiste en realizar la fase 01 de un software para el diseño de instalaciones eléctricas en baja tensión, con el fin de disminuir la cantidad de procesos manuales que hoy en día debe realizar el ingeniero, además de dar flexibilidad para la selección de los componentes de la instalación, al brindar la información de los elementos que se deben obtener de la forma más básica posible. Dentro de los procedimientos que se automatizaron se encuentran los siguientes: selección de calibre de conductores (AWG y mm2), selección de protección contra sobre corriente, cálculo de canalización, y el cálculo de regulación de tensión. La forma en que el software calcula el ultimo procedimiento, difiere de la tradicional puesto que se realiza un flujo de carga con el fin de demostrar si la fórmula que usualmente se utiliza es fiel al comportamiento de la instalación.
Para el aumento de calibre por el incumplimiento del límite de regulación, se realiza una heurística con la cual se identifica la peor ruta en cuanto a la caída de tensión, dado que se realiza una expansión del sistema se puede analizar cada fase de un alimentador, y se toma como representativa aquella que tiene mayor caída de tensión. Luego se escoge el alimentador con la peor regulación, impactando sobre la parte económica de la instalación puesto que solamente se cambian los conductores obligatoriamente necesarios. In the field of low voltage electrical installations is usually designed with MACROS in Excel, which save time by performing some calculations automatically, however, most of the work is still the responsibility of the designer engineer, who must select all The elements of the electrical installation. Although several software has been made for this type of design, the fact that they are created by companies that market the products of the installation, makes the selections are focused on references of their articles.
This project consists of performing first version of a software for the design of low voltage electrical installations, in order to reduce the amount of manual processes that the engineer must perform today, in addition to giving flexibility for the selection of the components of the installation, by providing the information of the elements that must be obtained in the most basic way possible. Among the procedures that were automated are the following: selection of gauge conductors (AWG and mm2), selection of protection against over current, calculation of pipeline, and calculation of voltage regulation. The way the software calculates the last procedure, differs from the traditional one since a load flow is made in order to demonstrate if the formula that is usually used is faithful to the behavior of the installation.
In order to increase the gauge due to the non-compliance with the regulation limit, a heuristic is performed with which the worst route is identified in terms of voltage drop, since an expansion of the system can be analyzed each phase of a feeder, And the one with the greatest voltage drop is taken as representative. Then the feeder is chosen with the worst regulation, impacting on the economic part of the installation since only the necessary drivers are changed.